Product


Straightener Towers (Vehicle Lock Nut Setting Type)




pulling tower / image1


more imformation

PULLING TOWER

PT-800H / PT-1100H (PAT)

For light/medium extend damaged vehicles.

The most suitable for the pulling work of monocoque body.

Wide space is not required to use it due to compact design.

Our anchor nuts are used to bury in the ground so that itfs possible to move the tower or the garage jack in the working place as there hasnft any convex obstacle on the ground for fixing the tower.

It is also available to supply hand-powered model (PT-800L) if you wish to get the reasonable model.

more imformation

-----------------------------
If you purchase PT-800H or PT-1100H only, the following items are needed separately.

In case of PT-800H (AP-80 Air Pump + *PT-800-30 + Anchor nuts for additional if you need.

In case of PT-1100H (AP-80 Air Pump +*PT-1100-30 +Anchor nuts for additional if you need.


*PT-800-30 consists of Anchor parts kit, Anchor plate (1 piece), Anchor nut (6 pcs.), Drive jig (1 piece) and Plate fix bolt (2 pcs.).

*PT-1100-30 consists of Anchor parts kit, Anchor plate (1 piece), Anchor nut (12 pcs.), Drive jig (1 piece) and Plate fix bolt (4 pcs.).

Note:
The thickness of concrete - Need 10cm.
Usable concrete drill - 22cm in diameter.
Special order products:
Attachment for rail, Attachment for base & Attachment for anchor pot.



PT-800-35 / PT-1100-35 EXTENSION FRAME
This is one of the powerful options for drawing works for a pillar and a roof rail.
There are exclusive frames for PT-800 and PT-1100 respectively.
Easy installation works for the safety design (bolt lock type).